Product Information:
A two-pack polyamide epoxy primer/finish with good corrosion, abrasion resistance. Excellent long term anticorrosive protection specifically for ballast tank, cargo holds, crude oil tank, adheres to an abroad range of substrates and existing coatings. Recommended for higher requirement surface treatment mainly blasting. Meets the requirements of compatibility with various cathodic protection systems. Also meets the criteria those for foods contact according to the FDA section 21, chapter 175.300. It is a very good choice where surface preparation is upgraded.
Recommended Purpose:
Economical for high build applications with long Overcoating intervals, above water and below the water line esp. Crude oils, Cargos, Ballast. Could overcoated with many Generic types of paints.
Physical Properties:
Color: Red Brown, Grey, Green, Black
Sheen: Glossy low
Volume Solids (%): 67 + 2
Theoretical Coverage: 5.36 m2 / lt at 125 microns dry / 187 microns wet
Recommended Film Thickness: Over 250 microns dry by 2 coats.
Flash Point: Mixed product >27oC
VOC: 287.10g/lt (material as into the container)
Drying and Overcoating Conditions
|
Temperature of basis material
|
5oC
|
23oC
|
30oC
|
|
Touch Dry
|
16 hours
|
6 hours
|
4 hours
|
|
Hard Dry
|
24 hours
|
12 hours
|
10 hours
|
|
Repainting interval (Min)
|
18 hours
|
8 hours
|
6 hours
|
|
Repainting interval (Max)
|
Always less than 30 days, depending on
environment temperature; best period between
2 days- 7 days
|
Pack Size: Basis 20lt drum, agent 5lt drum. If other packing specifications are needed, please consult with our Kylin Company.
|
